In the morning, when you leave the bathroom with lazy steps, blurring the light reflected from the faucet’s radiant shell, you unscrew the faucet’s slippery handle, and the water wakes you up, wakes you up, and the faucet shuts off a new day in your life. Let me tell you how to install the basin faucet!
- Single hole basin faucet installation method
When buying a single handle basin faucet, you should pay attention to the diameter of the spout. Most of the pipes on the market today are hardened, so pay attention to the height of the water inlet. 35 working points from the basin is most appropriate. Always choose a special angle valve for the installation and the angle valve must be fixed to the hot and cold water pipes of the wall outlet. When you find that the angle valve is at a distance from the water pipe on the faucet, purchase a special extension pipe to connect it. Keep in mind that you should not connect it with any other water pipe, because if the water pressure is too high, it can easily fall off and leak, causing you damage. If the incoming pipe is too long and over the outgoing pipe, you can cut off part of it as per your need. If the angle is not right, you can bend it to where you need it to be as needed. Remember. Don’t bend it hard to 90 degrees or more than 90 degrees. When installing the basin for water access, please don’t forget to purchase the small port for the faucet (the faucet is short). Don’t forget to rinse out the buried pipes before installation.
- Installation of the thermostat
Before installing the thermostatic faucet, please check whether the water pipes are hot left and cold right. Remember not to connect the hot and cold water pipes wrongly so that the faucet will not work properly. Gas water heaters and solar water heaters cannot use the thermostatic faucet due to the low water pressure. Please don’t forget to install the cold and hot water filter while installing the thermostatic faucet.
- Installation of single hole kitchen faucet
Stability is required, because the kitchen faucet is used frequently and moved and moved around a lot, so it is easy to loosen, so the lock nut must be tightened. Currently, some faucets appear on the market for additional nuts to secure the screws. This stability effect is very good. It will be a popular trend in the future if it can solve the problem of water removal.