How to Install A Bridge Kitchen Faucet with Sprayer

How to Install a Bridge Kitchen Faucet with Sprayer

A bridge kitchen faucet has a raised body that connects the hot and cold handles to the center spout, giving it a classic, vintage look. Installing a bridge kitchen faucet with a side sprayer takes a little longer than a single-handle faucet because the faucet uses multiple mounting holes.

Before you begin, confirm that your sink has the right hole configuration. A bridge faucet with a sprayer usually needs four holes: two for the handles, one for the spout, and one for the side sprayer. If your sink has extra holes, cover them with a deck plate or a soap dispenser.

Step 1: Turn off the water and remove the old faucet

Shut off the hot and cold valves, disconnect the supply lines, and remove the old faucet and sprayer. Clean the sink surface around the holes.

Step 2: Mount the bridge faucet

Feed the faucet hoses and mounting studs through the sink holes. Set the bridge body in place, then tighten the mounting nuts from under the sink until the faucet is secure.

Step 3: Install the side sprayer

Drop the sprayer head into its hole, then connect the sprayer hose to the diverter outlet under the sink. Tighten the sprayer mounting nut from below.

Step 4: Connect the water lines and test

Attach the supply lines to the angle stops, turn the water on, and test both the spout and the side sprayer. Check for leaks and tighten any loose connections.

Tools You Need to Install a Bridge Kitchen Faucet

A bridge kitchen faucet installation usually requires a basin wrench, adjustable pliers, plumber’s tape, a bucket, and a towel. Because a bridge faucet has two handles and a separate spout, you may also need a small flashlight to see the mounting nuts under the sink. If the faucet includes a side sprayer, the kit should have the sprayer hose and a diverter connection.

Step-by-Step Bridge Faucet Installation with Sprayer

Step 1: Turn off the water and remove the old faucet

Close both shut-off valves, open the old faucet to release pressure, and disconnect the supply lines. Loosen the mounting nuts and lift the old faucet and sprayer out, then clean the sink surface around the holes.

Step 2: Install the deck plate if needed

If the sink has extra holes, set the deck plate or escutcheon in place with a thin bead of silicone or plumber’s putty. Press it down and wipe away any excess.

Step 3: Mount the bridge faucet body

Feed the hot and cold supply hoses and the mounting studs through the appropriate holes. Lower the bridge body into place, then tighten the mounting nuts from below with a basin wrench. Keep the faucet straight while you tighten.

Step 4: Install the side sprayer

Drop the sprayer into its hole and secure it from below with the mounting nut. Connect the sprayer hose to the diverter outlet on the faucet body.

Step 5: Connect the supply lines and test

Attach the supply lines to the hot and cold angle stops, turn the water on slowly, and test the spout and sprayer. Tighten any fitting that drips.

Bridge Faucet Installation Tips

Do not over-tighten the mounting nuts, because the bridge body can crack. Hand-tighten first, then turn each nut only a quarter to half turn more. If the faucet wobbles, check that the gasket is centered under the base rather than forcing the nuts.

After installation, run both handles for a minute and watch the connections under the sink. A bridge faucet has more connections than a single-handle faucet, so it is important to check every joint, including the sprayer hose, before you put everything away.

Related Guides

n

n
• What are The Different Types of Bathroom Faucets

n

• Best White Kitchen Faucets – Buying Guide & Reviews

n

• The Best Faucet Brands to Consider in 2026

n

• What is The Standard Size Hole for A Kitchen or Bathroom Faucet

n

n