Faucet Leaks And Clogging Is Too Annoying. And 3 Methods Can Easily Fix!

2022/08/11 ClassificationBlog 1220 0

Faucet Leaks And Clogging Is Too Annoying. And 3 Methods Can Easily Fix!

Summer is the peak period of water use.

In these months, the water consumption of many homes will drift up.

But after the faucets in the house are used for a long time, they all have problems such as leaks and clogging. These are very annoying to people.

Today I will teach you a few tricks to easily solve the faucet leakage, clogging problem without spending a penny, and also give you a comfortable water experience.

Common problems of faucets

Problem one: water leakage from the spout

Cause of failure: Generally, this is caused by the loosening or wear of the axial gasket inside the faucet. Sometimes because the water quality in your own home is too poor, this makes a lot of garbage accumulate inside the faucet. If we do not regularly clean up, it will lead to the spool inside the valve closure not tight, and then the faucet will drip.

Solution: Loose displacement will be divided into two cases: one, the loose pressure cap leads to failure to seal the water. Then we just need to tighten the pressure cap. Another situation is a deformation of the rubber ring at the bottom of the valve spool, resulting in the inability to seal the water. In this case, we just need to reset the rubber ring. If the wear is serious, you need to replace the rubber ring.

If the pressure cap is loose, try this.

First of all, open the plastic cover on the top of the faucet, followed by a tool to unscrew the screws below.

After unscrewing the screws, take off the handle of the faucet.

Finally, use a tool to tighten the pressure cap.

If the washer is deformed, try this.

Gently pry off the protective tab on the handle (usually glued on). Unscrew the set screw on the handle. With a little force, you can pull off the handle directly, and the gasket is on the lower end of the shaft. Replacement with a new gasket will solve the problem (note the selection of gaskets of the same size).

Problem two: the faucet is clogged, resulting in slow water

Cause of failure: If you find that the faucet’s water output is getting smaller and smaller, it is possible that the drain is clogged. At this point you can unscrew the faucet filter head to see if there is debris stuck in here, and clean up the bubbler filter scale or debris limescale and other dirt.

Solution: remove the faucet and clean the filter. After clearing the clean, the water output of the faucet will increase. When the filter head is cleaned, ensure that the water is clean. If you encounter inconvenient to remove, you can dip the cotton ball into some white vinegar, and then put it under the faucet spout and press for about 5 minutes. After 5 minutes, the faucet can also drain normally.

If you think it is troublesome to keep pressing, you can put the white vinegar in a plastic bag. Then the plastic bag will be tied to the faucet so that the vinegar and the spout are in full contact, thus unclogging the drain.

Problem three: rusty faucet with dirt

Cause: After a long-term wet environment in the bathroom, the faucets and shower heads are prone to scale. Over time, they will be easy to rust.

Cleaning methods:

Use toothpaste

First wet the place with rust with water, then gently scrub with a soft cloth dipped in toothpaste, and finally rinse with water. It can be repeated several times until the rust is removed.

Use potato peels

Use potato peels to repeatedly wipe the surface of the stainless steel faucet. You will find that the dirt and scale will slowly be cleaned off.

With ketchup

Do not rush to dump the leftover ketchup. Dip an appropriate amount of ketchup and apply it to the rusty part of the faucet. Leave it on for about 5 minutes, then wipe it with a wet rag, and the rust will be gone immediately.

Use white vinegar

Wrap a towel around the faucet and pour white vinegar on it. Because white vinegar is corrosive, if poured directly on, it may damage the faucet. After five minutes, remove the rag and wipe the stain at the crevice with a toothbrush. The sink will be cleaned very well. You can also just use toilet paper. Soak them in white vinegar. After putting them on the faucet for five minutes, the stains on the faucet will be clean automatically.