Hot & Cold Brass Cartridge Replacement for WOWOW Shower Faucet (Model: 3090600D)

Hot & Cold Brass Cartridge Replacement for WOWOW Shower Faucet

USD25.99

Sold:

Reviews:

DIRECT FIT FOR WOWOW SHOWER FAUCETS — Engineered as an exact replacement for WOWOW shower and tub-shower valves. Same splines, same length, same seal position as the original cartridge, so your handle sits at the correct angle and the trim plate lines up the way it did on day one.
SOLID BRASS, NOT PLASTIC — Machined from forged brass instead of the molded plastic used in budget cartridges. Brass resists heat cycling, mineral scale and the constant pressure that cracks plastic bodies, so the repair lasts years instead of months.
SMOOTH, PRECISE HOT & COLD CONTROL — Polished ceramic discs glide instead of grind, giving you fine temperature adjustment and a light handle feel. No more overshooting from scalding to freezing with a tiny turn of the lever.
FIXES THE THREE MOST COMMON FAUCET FAILURES — Replaces the worn cartridge behind a constant drip, a handle that has gone stiff or loose, and water that runs lukewarm no matter which way you turn it. Far cheaper than replacing the entire faucet or opening the wall.
10-MINUTE DIY REPAIR, NO PLUMBER NEEDED — Shut off the water, pull the old cartridge, drop this one in. Only basic hand tools required, and pre-lubricated O-rings mean no extra plumber’s grease. Most customers finish before the coffee gets cold.

When a WOWOW shower faucet starts dripping, sticking, or losing its hot water, the faucet itself is almost never the problem. The cartridge inside it is. It is the one part that moves every single time you shower, and after a few years of hot water, hard water and daily use, its seals wear down. Replacing that one part restores the faucet completely — for a fraction of the cost of a new unit, and without cutting into your wall.

Built to Outlast the Part It Replaces

This cartridge is machined from forged brass, the same material used in the valve body itself. Inside, matched ceramic discs handle the mixing. Ceramic is the reason a good cartridge feels smooth and holds a temperature: the discs seal against each other with no rubber washer to harden, crack and start weeping. The O-rings arrive pre-lubricated and ready to seat.

A Repair Anyone Can Do

You do not need a plumber for this. Turn off the water supply, remove the handle and trim, pull the retaining clip, slide the old cartridge out and the new one in. The keyed stem only goes in one way, so it is difficult to install incorrectly. Most people are done in about ten minutes with a screwdriver and a pair of pliers.

Backed by WOWOW

This is a genuine WOWOW replacement part, made to the same tolerances as the cartridge originally installed in your faucet — not a generic universal fit that “mostly” works.

Reviews

There are no reviews yet.

Reviews

You may also like